Attaching The Stand - Sharp AQUOS LC-32D77X Operation Manual

Preparation

Attaching the stand

• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work, spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
Confi rm the 8 screws supplied with the TV.
1
LC-32D77X
Short screws (g4)
(used in step 3)
LC-42D77X/LC-46D77X/LC-52D77X
Short screws (g4)
(used in step 3)
Attach the supporting post for the stand unit
2
onto the base as shown below.
LC-32D77X
Screw
LC-42D77X/LC-46D77X/LC-52D77X
6
52D77X.indb 6 52D77X.indb 6
Short screws (g4)
(used in step 2)
Long screws (g4)
(used in step 2)
Screw
driver
(not supplied)
Long screw
Hex
key
1 Insert the stand into the openings on the
3
bottom of the TV.
2 Insert and tighten the 4 short screws into
the 4 holes on the rear of the TV.
LC-32D77X
LC-42D77X/LC-46D77X/LC-52D77X
NOTE
• To detach the stand, perform the steps in reverse order.
CAUTION
• Adjust the screen with both hands. Put one hand
on the TV and rotate the screen while steadying the
stand with your other hand.
The TV can be rotated up to 15 degrees to the right or left.
Soft
Screw
cushion
driver
(not supplied)
2
Screw
1
Hex key
Short screw
Soft
cushion
15°
15°
2/17/09 5:13:00 PM 2/17/09 5:13:00 PM