Cradlepoint MBR1400 Product Manual page 16

MBR1400 | USER MANUAL – Firmware version 4.2
CRADLEPOINT
LAN and WAN Ports: By default, the four orange ports are configured as LAN (Local Area Network) ports and the blue
port is configured as a WAN (Wide Area Network—your Internet source) port. Any LAN port, however, can be
reconfigured as a WAN port and vice versa.
Modem Ports: The MBR1400 has three USB 2.0 ports and two ExpressCard ports.
WiFi Antenna Connectors: Your router comes with three 2.4 GHz WiFi antennas (Reverse SMA). 5 GHz antennas are
available as an accessory. The antennas are simple to attach and adjust for maximum WiFi broadcast. (Finger tight only.)
Factory Default Reset: You can return your router to factory default settings by pressing and holding the Reset button.
This button is recessed, so it requires a pointed object such as a paper clip to press. Press and hold for 10 seconds to
initiate reset.
WPS Button: WiFi Protected Setup. When you press the WPS button for five seconds, it allows you to use WPS for WiFi
security. The LED will illuminate blue to indicate WPS status. Devices must support WPS in order to be configured by this
method.
Power On/Off:
• I = On
• O = Off
WiFi Broadcast On/Off: You have the option to turn off the WiFi radio.
• I = On
• O = Off
3G/4G Modem Signal Strength Button: When pressed the bar LEDs indicate signal strength from the CradlePoint
business-grade modem or USB or ExpressCard modem. The signal strength is shown for 10 seconds if the modem does
not support concurrent data connection and signal strength measurement. Tapping this button will toggle the Modem
Signal Strength display on and off.
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 14