Neuron Id For Rms Module; Resetting The Rms Module - Meyer Sound 1100-LFC Operating Instructions Manual

Wink/Activity LED (Green)
The green Wink/Activity LED indicates the status of the
loudspeaker:
■ During startup, the LED blinks 10 ten times.
■ If the loudspeaker has not yet been commissioned, the
LED is not lit after startup.
■ If the loudspeaker has been successfully commissioned,
the LED flashes continuously and flashes more rapidly
with increased data activity.
■ When the loudspeaker is winked, either by clicking the
Wink button in the RMS software or by pressing the
Identify button on the RMS user panel, the LED is solid
green.
TIP: The Wink function is useful for identifying
the physical loudspeaker corresponding to a
loudspeaker icon in the RMS software.
NOTE: The Wink/Activity LED on the RMS user
panel is used exclusively by RMS and has no
effect on the acoustical or electrical activity of the
1100-LFC loudspeaker.
Network Connectors
The two Weidmuller connectors transfer data to and from
the RMS network. Two connectors are provided to allow for
easy connection of multiple (daisy-chained) loudspeakers
on the network. Included with each RMS-equipped loud-
speaker are RMS cable connectors and mounting blocks for
constructing RMS cables. The RMS blocks allow the cables
to be securely attached to the RMS module with screws.

NEURON ID FOR RMS MODULE

Each 1100-LFC RMS module has a unique 12-character
Neuron ID (NID) that identifies the loudspeaker on the net-
work. When commissioning the loudspeaker, the NID must
either by entered manually or retrieved from the loudspeaker
by pressing its Identify button. The NID for the 1100-LFC
RMS module is located on the user panel below the orange
RMS Network connectors (see Figure 5 on page 26).

RESETTING THE RMS MODULE

You can use the Identify button to reset the 1100-LFC RMS
module when powering up the loudspeaker. This will cause
the module to be decommissioned from the network.
To reset the 1100-LFC RMS module:
1. Disconnect the loudspeaker's power cord.
2. Press and hold the Identify button.
3. While continuing to hold down the Identify button, recon-
nect the power cord.
4. After the Wink/Status LED blinks on and off, release the
Identify button. The 1100-LFC RMS module is reset and
the loudspeaker is decommissioned.
1100-LFC OPERATING INSTRUCTIONS
27