Neuron Id For Rms Module; Resetting The Rms Module - Meyer Sound 1100-LFC Operating Instructions Manual

Low-frequency control element
Hide thumbs Also See for 1100-LFC:
Table of Contents

Advertisement

CHAPTER 5: RMS REMOTE MONITORING SYSTEM
Identify Button
The Identify button serves the following functions:
• If the loudspeaker has not yet been discovered on the
RMS network (Wink/Activity LED not lit), press the Iden-
tify button to discover it.
• To remove the loudspeaker from the RMS network,
press and hold the Identify button during startup (see
"Resetting the RMS Module" on page 26).
• To wink a discovered loudspeaker, press the Identify
button. The Wink LED on the loudspeaker icon in Com-
pass RMS lights up and the Wink/Activity LED on the
loudspeaker's RMS user panel turns solid green. Press
the Identify button again to unwink the loudspeaker.
TIP:
The loudspeaker can also be winked by
clicking the Wink button on the loudspeaker
icon in Compass RMS.
Wink/Activity LED (Green)
The green Wink/Activity LED indicates the status of the
loudspeaker:
• During startup, the LED flashes green 10 times.
• If the loudspeaker has not yet been discovered on the
RMS network, the LED is not lit after startup.
• If the loudspeaker has been successfully discovered on
the RMS network, the LED flashes green continuously
and flashes more rapidly with increased data activity.
• When the loudspeaker is winked, either by clicking the
Wink button in Compass RMS or by pressing the Identify
button on the RMS user panel, the LED is solid green.
The LED remains solid green until the loudspeaker is
unwinked.
TIP:
The Wink function is useful for identifying
the physical loudspeaker corresponding to a
loudspeaker icon in Compass RMS.
RMS Network Connectors
The Weidmuller 2-conductor, locking connectors transfer
data to and from the RMS network. Two connectors are pro-
vided to allow for easy connection of multiple (daisy-
chained) loudspeakers on the network. Included with each
RMS-equipped loudspeaker are RMS cable connectors and
mounting blocks for constructing RMS cables. The RMS
blocks allow Weidmuller connectors to be securely attached
to the RMS module with screws.
26

NEURON ID FOR RMS MODULE

Each RMS module has a unique 12-character Neuron ID
(NID) that identifies the loudspeaker on the network. The
NID is automatically detected by RMServer but can also be
entered manually, if necessary, when configuring RMS sys-
tems in Compass RMS without loudspeakers present. The
NID label is located on the RMS user panel near the orange
Network connectors.

RESETTING THE RMS MODULE

Use the Identify button to reset the 1100-LFC RMS module
when powering on the loudspeaker. This action will cause
the module to be removed from the RMS network.
To reset the RMS module:
1. Power down the loudspeaker.
2. Press and hold the Identify button.
3. While continuing to hold down the Identify button, power
on the loudspeaker.
4. After the Wink/Status LED flashes on and off, release the
Identify button. The RMS module is reset and the loud-
speaker is removed from the RMS network.

Advertisement

Table of Contents
loading

Table of Contents