Mas-1100 Array Spacer - Meyer Sound 1100-LFC Operating Instructions Manual

Low-frequency control element
Hide thumbs Also See for 1100-LFC:
Table of Contents

Advertisement

CHAPTER 4: QUICKFLY RIGGING
MTG-1100 Pickup Configurations
The MTG-1100 top grid accommodates a variety of pickup
configurations with its six pickup points, three each on the
front and rear of the grid. When possible, use the front and
rear pickup points to change the tilt of the grid with the front
and rear motors. You can also bridle between pickup points
for greater stability, as compared to single front and rear
pickup points.
4 to 1 Corner Point Configuration (Left), 4 to 2 Corner Cross Point
Configuration (Right)
CAUTION:
Always use properly rated rigging
hardware. The MTG-1100 top grid requires
7/8-inch shackles for its pickup points.
CAUTION:
When using bridles between pickup
points on the MTG-1100, the angle of the bridle
at the apex should not be greater than 90 degrees to
avoid increasing the load on the bridles and damag-
ing the grid.
22

MAS-1100 ARRAY SPACER

The optional MAS-1100 array spacer can be placed
between cabinets to lengthen 1100-LFC arrays, improving
vertical directionality. Similar to an 1100-LFC equipped with
the MRK-1100 rigging kit, the MAS-1100 array spacer
includes four captive GuideALinks that extend up and into
the link slots of the cabinet above. The links extend and
retract with recessed knobs and are secured with the same
1/2 x 1.50-inch quick-release pins included with the
1100-LFC. The array spacer has four bottom slots, two on
each side, that accept GuideALinks from the cabinet below.
7/8-inch
shackles
required
for pickup
points
MAS-1100 Array Spacer with Two 1100-LFCs, Exploded View
The MAS-1100 array spacer is symmetrical and its front/rear
orientation does not matter when attaching to 1100-LFCs.
The array spacer attaches at a fixed splay angle of 0 degrees
and accommodates reversed units for cardioid arrays.
sions, and weight, refer to the MTG-1100 Assembly
Guide (PN 05.220.030.01) available at
sound.com.
NOTE:
For more information on the MAS-1100
array spacer, including its kit contents, dimen-
www.meyer-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents