Installation - Jensen JWM990 Installation And Operation Manual

INSTALLATION

It's a good idea to read all of the instructions before beginning the installation. We recommend
having your Jensen JWM990 installed by a reputable RV dealership
Tools and Supplies
You will need these tools and supplies to install your JWM990:

Phillips screwdriver

Wire cutters and strippers

Tools to remove existing radio (screwdriver, socket wrench set or other tools)

Electrical tape

Crimping tool

Volt meter/test light

Crimp connections

16 gauge wire for power connections

16 – 18 gauge speaker wire

Four M3x20mm (3/32 x 0.75") screws
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery
cable prior to installation.
NOTE: If the JWM990 is to be installed in a vehicle equipped with an on-board drive or
navigation computer, do not disconnect the battery cable. If the cable is disconnected,
the computer memory may be lost. Under these conditions, use extra caution during
installation to avoid causing a short circuit.
Selecting the Mounting Location
Select a mounting location, taking care to avoid the following:

Places exposed to heat-radiating appliances such as electric heaters

Adjacent to other equipment that radiates heat

Poorly-ventilated or dusty places

Moist or humid locations
Mounting the Radio

Use the mounting hole diagram to measure and cut a mounting hole

Route power, speakers, AV, and antenna cables through the hole and connect

Check and ensure correct operation

Mount the unit using four M3x20mm (3/32 x 0.75") screws

Attach Trim ring
NOTE: Before cutting the mounting hole, make sure the area behind the mounting
location is clear of wires, fuel and vacuum or brake lines.
Tabletop Mounting
The included mounting feet allow the JWM990 to sit in an entertainment center if you prefer not
to use the wall mounting method.
3
JWM990
THREADED MOUNTING FEET (INCLUDED)
RUBBER FEET (INCLUDED)