Switching The Warning Tone; Switching The Auxiliary Setting; Setting The Rear Output And Subwoofer Controller - Pioneer AVH-P6450CD Operation Manual

Initial Settings

Switching the warning tone

If the operation panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can turn
off this warning tone.
1 Press 5 or ∞ to select
from the INIT MENU, and press
DETACH WARNING adjustment indications are
displayed.
ON or OFF with 5/∞.
2 Select
WARNING:
Pressing 5/∞ will switch
and that status will be displayed
ON and OFF
(e.g., ).
WARNING :ON

Switching the auxiliary setting

It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press 5 or ∞ to select
MENU, and press
A.MENU
AUX adjustment indications are displayed.
ON or OFF with 5/∞.
2 Select
AUX
Pressing 5/∞ will switch
and that status will be displayed (e.g.,
OFF
).
AUX :ON
DETACH WARNING
.
A.MENU
between
WARNING
from the INIT
AUX
.
between
AUX ON and
Setting the rear output and sub-
woofer controller
This product's rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (
REAR SP:FULL
subwoofer (
REAR SP:S.W
switch rear output setting to the
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (
REAR SP:FULL
When rear output are connected to full range
speakers (when
REAR SP:FULL
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller's (low pass
filter, phase) built-in
S.W CTRL:INTERNAL
the auxiliary
S.W CTRL:EXTERNAL
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 48) or subwoofer output
(refer to page 48) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press 5 or ∞ to select
INIT MENU, and press
REAR SP adjustment indications are displayed.
2 Change the rear output setting with 5/∞.
Pressing 5/∞ will switch between
(full-range speaker) and
:FULL
(subwoofer) and that status will be displayed.
) or
) connection. If you
,
REAR SP:S.W
).
is selected), you
or
.
from the
REAR SP
.
A.MENU
REAR SP
REAR.SP :S.W
En
Section
11
51