Operation Lamp - Mitsubishi Electric Mr.Slim PKH-2FKA Technical & Service Manual

Display
CENTRALLY
CONTROLLED display
This indicates when the unit is con-
trolled by optional features such as
central control type remote controller.
w display
This indicates when the continuous
operation and time operation modes
are set.
It also display the time for the timer
operation at the same time as when
it is set.
OPERATION MODE display
This indicates the operation mode.
STANDBY display
This indicates when the standby
mode is set from the time the sleep
operation starts until the heating air
is discharged.
DEFROST display
This indicates when the defrost oper-
ation is performed.
CHECK display
This indicates when a malfunction
has occurred in the unit which should
be checked.
Caution
Only the display lights when the unit is stopped and power supplied to the unit.
When power is turned ON for the first time the (CENTRAL CTRL) display appears to go off momentarily but this is not a
malfunction.
When the central control remote control unit, which is sold separately, is used the ON-OFF button,
TEMP button do not operate.
"NOT AVAILABLE" is displayed when the
r display
The current time , start time and stop
time can be displayed in ten second
intervals by pressing the time switch
button. The start time or stop time is
always displayed during the timer
operation.
CHECK
This lamp lights when the filter need
to be cleaned.
—88
°C
This displays the selected setting
temperature.
button is pressed. This indicates that this room unit is not equipped with.
display
The selected fan speed is displayed.
j
display
This displays the air direction.
FILTER
CHECK MODE
TEST RUN
display
FILTER
display
4
In this display example on
the bottom left, a condition
where all display lamps light
is shown for explanation pur-
poses although this differs
from actual operation.
—88 display
°C
The temperature of the suction air is
displayed during operation. The dis-
play range is 8° to 39°C. The display
flashes 8°C when the actual temper-
ature is less than 8° and flashes
39°C when the actual temperature is
greater than 39°C.

Operation lamp

This lamp lights during operation,
goes off when the unit stops and
flashes when a malfunction occurs.
CHECK MODE
display
TEST RUN
This display lights in the check mode
or when a test operation is per-
formed.
Display
This lamp lights when electricity is
supplied to the unit.
button and i