Safety Requirements - Husqvarna 10527SB-LS Owner's Manual

Husqvarna snow blower user manual
Table of Contents

Advertisement

GAS O LINE
FILLER CAP
MUF FLER
CHOKE
CON -
TROL
PRIM ER
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AU GERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for start ing the
en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine.
LH and RH turn triggers - used to steer the snow thrower.
OPERATION
ELECTRIC
START BUTTON
RECOIL
(AUXILIARY)
STARTER
HANDLE
DE FLEC TOR
DISCHARGE
CHUTE
OIL DRAIN PLUG
CLEAN-OUT TOOL
FIG. 10
9
AUGER
DISCHARGE CHUTE CONTROL LEVER
CONTROL
LEVER
DRIVE SPEED
CON TROL LEVER
CHUTE
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Deflector remote control lever - used to change the
dis tance the snow is thrown.
Discharge chute control lever - used to change the di-
rec tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Drift cutter - used to cut through deep snowdrifts.
DEFLECTOR
TRACTION
REMOTE
DRIVE
CONTROL
CONTROL
LEVER
LEVER
LH TURN
TRIGGER
LIGHT
HANDLE
KNOB
MUF FLER
TOOLBOX
DRIFT
CUTTER
SKID PLATE

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

10527sbb10527sb-lsb96193003700

Table of Contents