ZyXEL Communications GS1920-24 User Manual page 336

Example: Uploading Firmware to a Cluster Member Switch
Figure 250
C:\>ftp 192.168.1.1
Connected to 192.168.1.1.
220 Switch FTP version 1.0 ready at Thu Jan
User (192.168.0.1:(none)): admin
331 Enter PASS command
Password:
230 Logged in
ftp> ls
200 Port command okay
150 Opening data connection for LIST
--w--w--w- 1 owner
-rw-rw-rw- 1 owner
--w--w--w- 1 owner
-rw-rw-rw- 1 owner
226 File sent OK
ftp: 297 bytes received in 0.00Seconds 297000.00Kbytes/sec.
ftp> bin
200 Type I OK
ftp> put 410AAHW0.bin fw-00-a0-c5-01-23-46
200 Port command okay
150 Opening data connection for STOR fw-00-a0-c5-01-23-46
226 File received OK
ftp: 262144 bytes sent in 0.63Seconds 415.44Kbytes/sec.
ftp>
The following table explains some of the FTP parameters.
Table 169 FTP Upload to Cluster Member Example
FTP PARAMETER
User
Password
ls
410AAHW0.bin
fw-00-a0-c5-01-23-46
config-00-a0-c5-01-23-46
Chapter 41 Cluster Management
group 3042210 Jul 01 12:00 ras
group 393216 Jul 01 12:00 config
group
group
DESCRIPTION
Enter "admin".
The web configurator password default is 1234.
Enter this command to list the name of cluster member switch's firmware
and configuration file.
This is the name of the firmware file you want to upload to the cluster
member switch.
This is the cluster member switch's firmware name as seen in the cluster
manager switch.
This is the cluster member switch's configuration file name as seen in the
cluster manager switch.
GS1920 Series User's Guide
336
1 00:58:46 1970
0 Jul 01 12:00 fw-00-a0-c5-01-23-46
0 Jul 01 12:00 config-00-a0-c5-01-23-46