Dhcp Server Settings - D-Link GO-RT-N150 User Manual

Section 3 - Configuration
DHCP stands for Dynamic Host Control Protocol. The D-Link GO-RT-N150 has a built-in DHCP server. The DHCP Server will
automatically assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be DHCP
clients by setting their TCP/IP settings to Obtain an IP Address Automatically. When you turn your computers on, they will
automatically load the proper TCP/IP settings provided by the router. The DHCP Server will automatically allocate an unused
IP address from the IP address pool to the requesting computer. You must specify the starting and ending address of the IP
address pool.
Enable DHCP
Check this box to enable the DHCP server on your
Server:
router. Uncheck to disable this function.
DHCP IP Address
Enter the starting and ending IP addresses for the
Range:
DHCP server's IP assignment.
Note: If you statically (manually) assign IP
addresses to your computers or devices, make sure
the IP addresses are outside of this range or you
may have an IP conflict.
Lease Time:
The length of time for the IP address lease. Enter
the lease time in minutes.
D-Link GO-RT-N150 User Manual

DHCP Server Settings

24