Auto Install Radio Stations; Set Clock; Turn On - Philips DCM3060 User Manual

Auto install radio stations

When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
» [AUTO INSTALL - PRESS PLAY
KEY](auto install - press play key) is
displayed.
2
Press on the main unit to start
installation.
» The unit automatically stores radio
stations with sufficient signal strength.
» When all the available radio stations
are stored, the first preset radio station
is broadcast automatically.

Set clock

Note
•
You can set the clock in standby mode only.
1
Press to switch the unit to standby.
• Make sure that --:-- (or clock) is
displayed (see "Turn on" > "Switch to
standby").
2
Press and hold PROG/CLOCK SET to
activate the clock setting mode.
» SET CLOCK is displayed.
» The 12 hour or 24 hour format is
displayed.
3
Press / to select 12 hour or 24
hour format.
4
Press PROG/CLOCK SET.
» The hour digits begin to blink.
5
/
Press to set the hour.
6
Press PROG/CLOCK SET.
» The minute digits begin to blink.
7
/
Press to set the minute.
EN
12
8
Press PROG/CLOCK SET to confirm.

Turn on

1
Press .
» The unit switches to the last selected
source.
Switch to standby
1
When the unit is turned on, press
switch the unit to standby.
• In standby, press and hold
from normal standby to Eco power
standby or vice versa.
» In normal standby, the clock (if set)
appears on the display panel.
» In Eco power standby, the backlight on
the display panel turns off.
to
to switch