Note
•
The type plate is located on the back of the
main unit.
1
If your power supply voltage is 110V-
127V, adjust the voltage selector to 110V-
127V.
2
Connect the AC power cable to:
•
the main unit.
•
the wall socket.
Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from
heat, sunshine or fi re. Never discard batteries
in fi re.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
3
1
2
Note
•
If you are not going to use the remote control
for a long time, remove the batteries.
•
Do not use old and new or different types of
batteries in combination.
•
Batteries contain chemical substances, so they
should be disposed of properly.
Auto install radio stations
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
[AUTO INSTALL - PRESS PLAY] (auto
»
install - press the PLAY button) is
displayed.
2
Press
on the main unit to start
installation.
[AUTO] (auto) is displayed.
»
The unit automatically stores radio
»
stations with suffi cient signal strength.
When all the available radio stations
»
are stored, the fi rst preset radio station
is broadcast automatically.
Set clock
1
In the standby mode, press CLOCK/
DISPLAY to activate the clock setting
mode.
The 12 hour or 24 hour format is
»
displayed.
2
Press ALB/PRESET+/- repeatedly to
select 12 hour or 24 hour format.
3
Press CLOCK/DISPLAY to confi rm.
The hour digits are displayed and begin
»
to blink.
4
Press ALB/PRESET+/- to set the hour.
5
Press CLOCK/DISPLAY to confi rm.
The minute digits are displayed and
»
begin to blink.
6
Press ALB/PRESET+/- to set the minute.
7
Press CLOCK/DISPLAY to confi rm.
Tip
•
To view the clock during play, press
DISPLAY repeatedly until the clock is
displayed.
CLOCK/
EN
11