Connect Power; Auto Install Radio Stations; Set Clock - Philips DCM278/37 User Manual

1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
If you are not going to use the remote control
for a long time, remove the batteries.
•
Do not use old and new or different types of
batteries in combination.
•
Batteries contain chemical substances, so they
should be disposed of properly.

Connect power

Caution
•
Risk of product damage! Ensure that the
power supply voltage corresponds to the
voltage printed on the bottom of the unit.
•
Before connecting the AC cord, ensure you
have completed all other connections.
Note
• The type plate is located on the rear of the
main unit.
1
Connect the AC cord to the AC outlet.
12 EN

Auto install radio stations

When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
» AUTO INSTALL - PRESS PLAY
[
KEY](auto install - press play key) is
displayed.
2
Press on the main unit to start
installation.
»
The unit automatically stores radio
stations with sufficient signal strength.
»
When all the available radio stations
are stored, the first preset radio station
is broadcast automatically.

Set clock

Note
•
You can set the clock in the standby mode
only.
1
Press PROG/CLOCK SET to enter the
clock setting mode.
» SET CLOCK](set clock) scrolls on the
[
screen.
2
Press / repeatedly to select 12 hour
or 24 hour format.
3
Press PROG/CLOCK SET to confirm.
»
The hour digits are displayed and begin
to blink.
4
Press / to set the hour.
5
Press PROG/CLOCK SET to confirm.
»
The minute digits are displayed and
begin to blink.
6
Press / to set the minute.
7
Press PROG/CLOCK SET to confirm the
clock setting.