Connect Speakers; Connect Power; Auto Install Radio Stations; Set Clock - Philips DCM1075 User Manual

Connect speakers

Note
‡
For optimal sound, use the supplied speakers only.
‡
Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
6SHFLÀFDWLRQV VHFWLRQ RI WKLV PDQXDO
Insert the speaker wires completely into the
speaker input sockets on the back of the unit.

Connect power

Caution
‡
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the rear of the main unit.
‡
Before connecting the AC cord, make sure that you
have completed all other connections.
Note
‡
The type plate is located on the rear of the main unit.
1
Connect the power cord to the AC~ jack
on the main unit.
2
Connect the power plug to the wall outlet.

Auto install radio stations

When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
» [AUTO INSTALL - PRESS PLAY-
STOP CANCEL] (press
automatic installation, or press
cancel) is displayed.
2
Press on the main unit to start
installation.
» The unit automatically stores radio
VWDWLRQV ZLWK VXIÀFLHQW VLJQDO VWUHQJWK
» When all the available radio stations
DUH VWRUHG WKH ÀUVW SUHVHW UDGLR VWDWLRQ
is broadcast automatically.

Set clock

Note
‡
You can set the clock in standby mode only.
1
Press to switch the unit to standby.
2
Make sure that --:-- (or clock) is displayed.
3
Press and hold PROG/CLOCK SET to
activate the clock setting mode.
» [CLOCK SET] (clock set) is displayed.
» The 12 hour or 24 hour format is
displayed.
to start
to
EN 11