Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not use old and new or different types of batteries
in combination.
•
Batteries contain chemical substances, so they should
be disposed of properly.
Connect speakers
Note
•
For optimal sound, use the supplied speakers only.
•
Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
Specifications section of this manual.
Insert the speaker wires completely into the
speaker input sockets on the back of the unit.
Connect power
Caution
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the rear of the main unit.
•
Before connecting the AC cord, make sure that you
have completed all other connections.
Note
•
The type plate is located on the rear of the main unit.
1
Connect the power cord to the AC~ jack
on the main unit.
EN
8
2
Connect the power plug to the wall outlet.
Auto install radio stations
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
» [AUTO INSTALL - PRESS PLAY-
STOP CANCEL] (auto install - press
play - stop cancel) is displayed.
2
Press
on the main unit to start
installation.
» The unit automatically stores radio
stations with sufficient signal strength.
» When all the available radio stations
are stored, the first preset radio station
is broadcast automatically.
Set clock
Note
•
You can set the clock in standby mode only.
1
Press
to switch the unit to standby.
2
Make sure that --:-- (or clock) is displayed.
3
Press and hold CLOCK SET to activate
the clock setting mode.
» [CLOCK SET] (clock set) is displayed.
» The 12 hour or 24 hour format is
displayed.