Advertisement
-6.
CAUTIONS
1. For safety reasons, install the magazine only when the car is stationary. To pre-
vent accidents, it is best that the volume inside the car does not exceed that of
the outside.
2. Use a soft dry cloth to clean the unit. Do not use abrasive pads, benzene, thin-
ners or alcohol. For stubborn dirt, use a soft cloth, lightly moistened with (warm)
water and wipe gently.
3.• At the recess end of the flip down door lies the built-in pick up which is the core
part of the player. If dust or dirt comes into contact with this core part it will
cause damage to the the unit. Therefore, do not leave the flip down door open
for long periods of time.
-7.
TROUBLESHOOTING
• If the unit is played immediately after switching on the heater when the inside
of the car is extremely cold, the discs and the pick up will fog up.
If
this hap
pens, the unit may not work normally. (Condensation)
Use a soft cloth to wipe the disc when it fogs up. The fog will naturally disap-
pear in about one hour and thereafter the disc will work normally again.
4. While the system is in play, do not plug or unplug the cables as this will cause
damage.
5. Do not expose the magazine to direct sunlight, the car heater or other sources of
strong heat.
Sympton
Cause
Remedy
Loss of power
Bad connection
Check connections.
Magazine cannot be
Magazine inserted wrongly
Insert correctly.
loaded
A magazine is already in the player.
Eject the magazine and insert the other.
Distorted magazine
Buy New Magazine CAA-397.
"No Disc" sign appears
Disc inserted upside-down
Read the section on " INSERTING THE CD" carefUlly and reinsert the CD correctly.
when searching for discs.
Moisture or dirt on disc
Wipe disc free of moisture and dirt.
Noise, skipping
The installation selector levers are set to differ-
Set the installation selector levers to the same position on both sides.
ent positions on both sides.
The unit installation direction and the installation Set the unit installation direction and the installation selector lever positions to match each
selector lever positions do not match.
other. When installed at an angle, change the installation selector lever to a position (H,45°,V)
not prone to noise or sound loss.
Disc bent or badly damaged
Compare with another disc. If bad, discard the damaged disc.
Disc is very dirty
Clean the disc.
Mechanism does not
Mechanical error
<DReferring to section "INSTALLATION", check the three angle of installation selector levers are
function.
properly set. If not, set them at the proper position for the angle of installation.
<liCheck whether the CD magazine can be ejected by pressing eject button, then insert a new
CD magazine.
Magazine is ejected even Disc holder is not correctly inserted into the
Read the section on " INSERTING THE CD" carefUlly and reinsert the disc holder correctly.
when inserted into the
magazine.
unit.
-8.
SPECIFICATIONS
Sampling Frequency:
Frequency Response:
Signal to Noise Ratio:
Wow and Flutter:
Power Supply:
44.1 kHz
5Hz - 20kHz (± 1dB)
105dB (1kHz) IHF.A
Below measurement limits
DC14.4V (10.8 - 15.6V)
negative ground
Current Consumption:
Less than 1A
Weight:
3.6 lb. (1.65 kg)
*Due to improvements, the design and these specifications may be modified without prior notice.
-9.
HANDLING COMPACT DISCS
2-1/2"
(63mm)
E
E
(
I
.....
to
~
.j,
8-7/8"(225 mm)
1. When the inside of the car is very cold and the player is used soon after
switching on the heater, dew may form on the disc or the optical parts of the
player and proper playback may not be possible. If dew forms on the disc,
wipe it with a soft cloth. If dew forms on the optical parts of the player. do not
use the player for about one hour and the condensation will disappear natural-
ly to allow normal operation.
2. Driving on bumpy roads which cause severe vibration may cause the sound to
skip.
This unit has been designed specifically for reproduction of compact discs bearing the (@.~ mark. No other discs can be played.
To remove the compact disc from its storage case,
press down on the centre of the case and lift the
disc out, holding it carefully by the edges.
Removing the disc
Proper way to hold
~'~~
Always handle thr compact disc by the edges.
Never touch the surface.
To remove fingermarks and dust, use a soft c1oth,and
wipe in a straight motion from the centre of the com-
pact disc to the outside.
New discs may have some roughness around the
edge. The set may not work or the sound may skip if
such discs are used. Use a ball-point pen, etc., to
remove roughness from the edge of the disc.
r
Note on Compact Discs
Never stick labels on the surface of
the compact disc or mark the sur-
face with a pencil or pen.
Do not use any solvents such as
commercially available cleaners,
anti-static spray, or thinner to clean
compact discs.
Do not use compact discs that have
large scratches, are misshaped,
cracked, etc. Use of such discs will
cause misoperation or damage.
Do not expose compact discs to
direct sunlight or any heat source.
Note:
Do not use commercially available CD protection sheets or discs equipped with stabilizers, etc. These may get caught in the internal mechanism and damage the disc.
Advertisement
