Adjusting The Video - Pioneer BDP-160 Operating Instructions Manual

07
Setting
Screen Saver
Auto Power Off
Quick Start
Update
Load Default
System Information
BUDA
 Adjusting the video
Select and set Display Setting  Video Adjust.
1
Use / to select, then press ENTER.
2 Select Custom.
Use / to select, then press ENTER.
3 Select the item and change the setting.
Use / to select the item, then use / to change the
setting. Once the setting is completed, press
RETURN to close the settings screen.
List of setting items
Item
Brightness
Saturation
Hue
Contrast
Sharpness
CTI (Color Transient
Improvement)
 Setting the IP address
Select and set Network  IP Address Setting 
1
Next Screen.
Use / to select, then press ENTER.
2 Set IP address.
Use /// to set the IP address of the player or DNS
server, then press ENTER.
38
En
Options
Off
1 min
2 min
3 min
Off
10 min
20 min
30 min
On
Off
USB Storage
Network
Restore the settings to the factory default.
Check the system version number.
BUDA Information
BUDA Setup
Description
Select this to adjust the TV screen's
brightness.
Select this to adjust the TV screen's
saturation.
Select this to adjust the color (green and
red) balance of the TV screen.
Select this to adjust the TV screen's
contrast.
Choose the level of sharpness.
Provides images with clearer color
contours.
Explanation
The screen saver is not activated.
The screen saver will be activated if no operation has been performed for
more than one minute/two minutes/three minutes. Operating the remote
control can deactivate the screen saver.
Select this if you do not want the power to turn off automatically. This is the
default setting for models other than European models.
The power will be automatically turned off if no operation has been performed
for more than 10 minutes/20 minutes/30 minutes. The default setting for
European models is 30 minutes.
Select to shorten the required time to boot up.
Select to perform normal bootup.
Select the method of software updating (page 40).
Display and set up the BUDA data on the connected USB device (page 39).
• Auto Set IP Address
On – The player's IP address is obtained
automatically. Select this when using a broadband
router or broadband modem that has a DHCP
(Dynamic Host Configuration Protocol) server
function. This player's IP address will automatically
be allocated from the DHCP server.
Off – The player's IP address must be set manually.
Use the number buttons (0 to 9) to input the IP
address, subnet mask and default gateway.
Caution
• Some time is required for the IP address setting.
Note
• Once the IP address is set, select [Connection Test] to
check that the unit is properly connected.
• For information on the DHCP server function, refer to
the operating instructions for the network device.
• You may need to contact your Internet service
provider or network administrator when inputting the
IP address manually.
 Setting the proxy server
Only set the proxy server if so instructed by your Internet
service provider.
Select and set Network  Proxy Server  Next
1
Screen.
Use / to select, then press ENTER.
2 Select and set Use or Not use at Proxy Server.
Use / to change, then press .
• Use – Select this when using a proxy server.
• Not use – Select this when not using a proxy server.
If you have selected Use, proceed to step 3.