Table of Contents
Advertisement
Setting
Screen Saver
Auto Power Off
Quick Start
Update
Load Default
System Information
BUDA
Adjusting the video
Select and set Display Setting Video Adjust
1
Next Screen.
Use / to select, then press ENTER.
2
Select the item and change the setting.
Use / to select the item, then use / to change the
setting. Once the setting is completed, press
RETURN to close the settings screen.
Item
Description
Brightness
Select this to adjust the TV screen's
brightness.
Contrast
Select this to adjust the TV screen's
contrast.
Hue
Select this to adjust the color (green and
red) balance of the TV screen.
Saturation
Select this to adjust the TV screen's
saturation.
Options
Explanation
Off
The screen saver is not activated.
The screen saver will be activated if no operation has been performed for
1 min
more than one minute/two minutes/three minutes. Operating the remote
2 min
control can deactivate the screen saver.
3 min
Off
Select this if you do not want the power to turn off automatically. This is the
default setting for models other than European models.
10 min
The power will be automatically turned off if no operation has been performed
for more than 10 minutes/20 minutes/30 minutes. The default setting for
20 min
European models is 30 minutes.
30 min
On
Select to shorten the required time to boot up.
Select to perform normal bootup.
Off
USB Storage
Select the method of software updating. (page 35)
Restore the settings to the factory default.
Check the system version number.
BUDA Information
Display and set up the BUDA data on the connected USB device.
BUDA Setup
Setting the IP address
Select and set Network IP Setting Next
1
Screen.
Use / to select, then press ENTER.
2
Set IP address.
Use /// to set the IP address of the player or DNS
server, then press ENTER.
• Auto Set IP Address
On – The player's IP address is obtained
automatically. Select this when using a broadband
router or broadband modem that has a DHCP
(Dynamic Host Configuration Protocol) server
function. This player's IP address will automatically
be allocated from the DHCP server.
Off – The player's IP address must be set manually.
Use the number buttons (0 to 9) to input the IP
address, subnet mask and default gateway.
Note
• For information on the DHCP server function, refer to
the operating instructions for the network device.
• You may need to contact your Internet service
provider or network administrator when inputting the
IP address manually.
Setting the proxy server
Only set the proxy server if so instructed by your Internet
service provider.
Select and set Network Proxy Server Next
1
Screen.
Use / to select, then press ENTER.
2
Select and set Use or Not use at Proxy Server.
Use / to change, then press .
• Use – Select this when using a proxy server.
• Not use – Select this when not using a proxy server.
07
33
En
Advertisement
Chapters
Table of Contents
