By Pass Linkages; By-Pass Linkages - Husqvarna Z4219 Operator's Manual

4. By pass linkages

When pushing or pulling the mower, be sure
to engage the IZT (Integraded Zeroturn
Transaxle) bypass linkages. The IZT bypass
linkages are located on the rear of the frame,
below the rear engine guard.
• Raise the deck into the highest cutting
position.
• Pull the IZT bypass linkages out and into
the slots and release so that it is held in
the bypass position.
• To reengage the IZT's to drive, reverse
the above procedure.
CONTROLS
1. IZT Bypass linkage
Bypass linkages
1. Head outside of rear deck
2. IZT Bypass linkage in bypass position
Bypass position
8011-721
8011-722
19
English-