By Pass Linkage
When pushing or pulling the mower, be sure to engage
the IZT (Integrated Zeroturn Transaxle) bypass
linkages. The IZT bypass linkages are located on the
rear of the frame, below the rear engine guard.
•
Raise the deck into the highest cutting
position.
•
Pull the IZT bypass linkages out and into
the slots and release so that it is held in the
bypass position.
•
To reengage the IZT's to drive, reverse the
above procedure.
fuses
The fuses are located in a holder at the right hand side
of the battery compartment. They are flat pin fuses of
the same type used in automobiles.
There are two fuses.
Fuse ratings and functions:
•
20 A, Primary fuse.
•
7.5 A, Mower deck coupling.
22
-
English
CONTROLS
1. IZT Bypass linkage
Bypass linkages
1. Head outside of rear deck
2. IZT Bypass linkage in bypass position
Fuses
CZ10-2
1
2
CZ12
8011-483