Antenna With A Single Lead; Antennas With Separate Uhf And Vhf Leads - Mitsubishi Electric WD-52628 Owner's Manual

Connecting an Antenna with a Single Lead or Antennas with
Separate UHF and VHF Leads

Antenna with a Single Lead

(not for use with CableCARD™)
Figure 3
For antennas with flat twin leads
A 300-ohm-to-75-ohm transformer is required. This is not
included with the TV, but is available at most electronics stores.
1. For an antenna with flat twin leads, connect the
300-ohm twin leads to the 300-ohm-to-75-ohm
transformer.
2. Push the 75-ohm side of the transformer onto ANT-1
MAIN on the TV back panel.
For cable or antenna with coaxial lead
Connect the coaxial lead directly to ANT-1 MAIN on
the TV back panel.
Figure 3. Connecting a Single Antenna
IR EMITTER IR EMITTER
Net Command Net Command
DTV/CABLE/
VHF/UHF
ANT 1 / MAIN ANT 2 / AUX ANT 2 / AUX
Mitsubishi strongly recommends you avoid using
antennas with flat twin leads. Flat twin lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.
Antennas with Separate UHF and VHF
Leads
Figure 4
A UHF/VHF combiner is required. This is not included with the
TV, but is available at most electronics stores.
1. Connect the UHF and VHF antenna leads to the UHF/
VHF combiner.
2. Push the combiner onto ANT-1 MAIN on the TV back
panel.
DIGITAL
AUDIO
OUTPUT OUTPUT
Figure 4. Connecting separate UHF and VHF Antennas
Chapter 2. Connecting
COMPONENT COMPONENT
INPUT INPUT YPbPr (480i/480p/720p YPbPr (480i/480p/720p
1 1 2 2
1 1 2 2
S-VIDEO S-VIDEO S-VIDEO
VIDEO VIDEO
AUDIO- AUDIO-
LEFT/ LEFT/
(MONO) (MONO)
AUDIO- AUDIO-
RIGHT RIGHT
IR EMITTER IR EMITTER
Net Command Net Command
DTV/CABLE/
VHF/UHF
DIGITAL
AUDIO
ANT 1 / MAIN OUTPUT
ANT 2 / AUX ANT 2 / AUX
25