Finish Screen; Review Screen - Mitsubishi Electric WD-52628 Owner's Manual

Mitsubishi electric projection television owner's guide
Hide thumbs Also See for WD-52628:
Table of Contents

Advertisement

NetCommand

Review Screen

Figure 6
After you have made your device choices, the Review
Screen will display. It is important to review the settings
to ensure that they are correct. If necessary, you can
use <Back to return to the Device Setup screen to make
changes.
Figure 6. Review screen
Note: The Review screen lists the TV input and A/V
receiver input used with each device. You must
correctly identify the inputs you used when you
connected the devices. If you have not connected
your devices, write down these inputs as a guide. If
you cannot use these inputs, or if you would like to
change the name of a device, use the instructions in
Edit NetCommand to make necessary changes.
Note: If you select Next> on the Review screen, all
selections made are finalized.
On the Review screen, adding or deleting check marks
will turn the adjacent devices or inputs On or Off. 1394
device names only appear on the Review screen when
the devices are connected to the TV.

Chapter 3. NetCommand Setup and Editing
®
Initial Setup, continued

Finish Screen

Figure 7
To complete the NetCommand setup, select Finish
from the Finish screen.
If you wish to change any of the pre- configured
inputs or names for the devices, or add devices not in
the pre-configured setup, select Edit to display Edit
NetCommand menu.
If your A/V receiver was not listed, select Edit to add
the AVR and then assign all devices to new AVR inputs.
Figure 7. Finish screen
It may still be necessary to memorize the available
channels for Antenna-1 (and Antenna-2, if used).
You may do that by going to the TV Main menu and
selecting Setup. Instructions to memorize channels are
found in the Setup menu section.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd-62628Wd-73727

Table of Contents