Mitsubishi Electric WD-52628 Owner's Manual page 13

Mitsubishi electric projection television owner's guide
Hide thumbs Also See for WD-52628:
Table of Contents

Advertisement

Front Control Panel, continued
Status Indicator
Indicator Color
TV Condition
None (indicator off)
Normal TV on or standby condition.
Yellow, steady
Room temperature is too high.
Red, either steady or
TV may require service.
blinking
Power/Timer Indicator
Indicator Color
TV Condition
None (indicator off)
TV is powered OFF.
Green, steady
TV is powered ON.
Green, rapid blinking 1. TV just plugged into AC outlet.
2. AC just restored after power
3. TV Rebooting after System Reset
4. TV Rebooting after power
5. You have begun the procedure
Green, slow blinking
TV powered off and automatic-on
timer is set.
A/V Reset
There may be times when you wish to reset the A/V (Audio and Video) settings back to the factory defaults. To return
all the settings at once, press GUIDE and FORMAT on the front panel at the same time. To reset the defaults for
individual devices, use the A/V Memory Reset selection on the Audio/Video menu.
failure.
used.
fluctuation or receiving abnormal
digital signals from digital channel,
CableCARD™, or digital device.
to update software from an
authorized flash memory device.
Additional Information
Normal operation.
TV will not operate when the ambient room
temperature is too high. Turn off the TV and wait
until the room temperature drops.
Turn off the TV and unplug the set from the AC power
source. Wait one minute and then plug the set back
in.
If the LED is still on, contact your dealer or a
Mitsubishi Authorized Service Center. See
www.mitsubishi-tv.com or call 1-800-332-2119 to
receive Authorized Service Center information.
Additional Information
Normal operation.
Normal operation.
Wait until blinking stops before turning on
(approximately 1 minute). Normal operation.
Wait until blinking stops before turning on
(approximately 1 minute). Normal operation.
Wait until blinking stops before turning on
(approximately 1-2 minutes). Normal operation.
Wait until blinking stops before turning on
(approximately 1 minute). Normal operation.
For detailed information, see the instructions
that accompany the authorized software update.
Important: Do not use non-authorized software at
any time.
Normal operation. TV can be turned on at any time.
Chapter 1. Television Overview
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd-62628Wd-73727

Table of Contents