Sharp Aquos LC-32D5U Operation Manual page 93

@)-92
Appendix
Problem Possible Solution
• LISTINGS disappeared after a
• You should begin to receive listings again within 24 hours.
power failure.
··.n··_...··....
.................
-
.......
_
........
__
._
..
_
..... _ ...... ...............
_
..
_
.....
_-_
.......
n . . . . . . . . . . . . .
.............. _ ............................................... ......................................
. ........................................ - ..
__
.....
_-_.-_
........
• Some channel numbers in the TV
• You can correct them using "Changing channel display" under SETUP.
Guide On Screen are incorrect.
• You have not received any local
Listings usually appear within 24 hours after a successful Setup.
program listings.
• Check the connections between the TV, cable, antenna, and the G-L1NK cable if
using a cable box.
• Verify Setup information under "Changing system settings".
• Make sure the cable box is on, if applicable.
• Review step 4 and step 5 of "Basic Initial Setup" on page 21 .
• A program you set to record did
• Make sure your recorder is turned off before the recording begins.
not record.
• Make sure there is free space available for recording on the tape or recording
device.
• Check the SCHEDULE menu and verify that the program is listed, before
recording begins.
• Check the placement of the G-L1NK cable in front of your recorder.
• The TV did not tune to a program
• Check the SCHEDULE menu and verify that the program is listed.
you scheduled with the reminder
• If you have a cable box, check the G-L1NK cable.
feature.
• You set a program to "auto tune
• Check the SCHEDULE menu and verify that the program is listed as a Reminder.
TV" and it did not.
• Highlight the program under LISTINGS and do the following:
- Press MENU on the remote control.
- Use
T
to highlight "edit reminder", and press ENTER.
- Verify the "auto tune TV" option reads "yes".
• The TV must be on at the scheduled time for "auto tune TV".
• You set a program with the "power
• Check the SCHEDULE menu and verify that the program is listed as a Reminder.
on TV" option and it did not.
• Highlight the program under LISTINGS and do the following:
- Press MENU on the remote control.
- Use
T
to highlight "edit reminder", and press ENTER.
- Verify that the "power on TV" option reads "yes".
• The TV must be off at the scheduled time for "power on TV".