Useful Adjustment Settings; Image Position (Av Input Mode Only) - Sharp Aquos LC-32D5U Operation Manual

Useful adjustment settings
For adjusting a picturels horizontal and vertical
position.
Press MENU and the MENU screen displays.
Press
J../T Iott4l..
to Illove an illlage on the screen to
the desired position. Press ENTER to return to the initial
image position.
Press
~/
.. to select "Setup".
Press
J../T
to select "Position
l
' ,
and then
press ENTER.
Press
./T
to select "H-Pos." or "V-Pos.".
• While pressing
./~
/ ..
/~,
an on-screen image,
"Adjusting Position" displays to the desired position.
• This setting cannot be stored. Once the TV shuts down or
enters standby mode, the setting is erased. To move the
picture around the screen again, you must perform the
above procedure again.
• The image position setting using the steps on this page
can be stored. Select either according to your objectives .
• l<
TV
II ,
"INPUTf', "INPUT2", "INPUT3" and "INPUT4" can
each adjust the image position setting on this page. The
same for view modes.
• An on-screen image from PC cannot be ITioved around.
• Even when the image fills the screen, its position can be
adjusted with this function.
• Press ENTER to reset the image to original positions.
•
t
•
Press
~/~
to adjust the item to your desired
position.
• For resetting all adjustment items to the factory preset
values, press ./~ to select "Reset", and then press
ENTER.
• Adjustments are stored separately according to input
source.
• You can easily move the image position as shown on this
page, but when the power is switched off the image will
return to the previously mernorized position.
H-Pos.
Centers the image by moving it to the left
or right.
V-Pos.
Centers the image by moving it up or
down.
@-64