Table of Contents
Advertisement
NOTE
6.3. Diving in the GAUGE mode (DIVE Gauge)
If set to the GAUGE mode, the dive computer can be used as a bottom timer.
In the GAUGE mode, the total dive time is always displayed in minutes in the lower
right corner. In addition, a Dive Timer in the center window displays time in minutes
and seconds. The center window Dive Timer is activated at the start of the dive and
it can be reset during the dive and used as a stopwatch by pressing the SELECT
button.
NOTE
94
If no button is pressed in 15 seconds, the dive computer will
go back to the dive display without changing the gas mix.
Upon ascent, the computer prompts you to change gas when
the PO
level you have set for the next mix allows a gas
2
change. The prompt is a low priority alarm followed by the
"Change gas" beep, sounded once. The Gas mix (O2%) value
blinks.
The GAUGE mode does not provide decompression informa-
tion.
BY PRESSING THE SELECT
BUTTON DURING A DIVE, A BOOK-
MARK IS WRITTEN IN THE PROFILE
MEMORY, THE DIVE TIMER IS RESET,
AND THE PREVIOUSLY-TIMED
INTERVAL IS DISPLAYED BELOW.
Advertisement
Table of Contents
