Table of Contents
Advertisement
5.6. Error conditions
The dive computer has warning indicators that alert you to react to certain situations
that would significantly increase the risk of DCI. If you do not respond to its warnings,
the dive computer will enter an Error mode, indicating that the risk of DCI has greatly
increased. If you understand the dive computer and operate it sensibly, it is very unlikely
you will ever put the instrument into the Error mode.
Omitted decompression
The Error mode results from omitted decompression, for example, when you stay
above the ceiling for more than three minutes. During this three-minute period the Er
warning is shown and the audible alarm beeps. After this, the dive computer enters a
permanent Error mode. The instrument will continue to function normally if you descend
below the ceiling within this three-minute period.
When the dive computer is in the permanent Error mode, only the Er warning is shown
in the center window. The dive computer does not show times for ascent or stops.
However, all the other displays function as before to provide information for ascent.
You must immediately ascend to a depth of 3 to 6 m/10 to 20 ft and remain at this
depth until air supply limitations require you to surface.
After surfacing, you should not dive for a minimum of 48 hours. During the permanent
Error mode, the Er text is displayed in the center window and the planning mode is
disabled.
5.7. Wireless transmission
In order to use the transmitter, the wireless integration needs to be enabled in your
Suunto D6i settings. To enable or disable the wireless integration, refer to Section 5.8.3.
Setting the tank pressure pairing.
49
Advertisement
Table of Contents
