Diving In Gauge Mode (Divegauge) - Suunto Vyper2 User Manual

NOTE
NOTE

6.3. Diving in GAUGE mode (DIVEgauge)

If set to GAUGE mode, the dive computer can be used as a bottom timer.
In the GAUGE mode, the total dive time is always displayed in minutes in the lower right
corner. In addition, a Dive Timer in the center window displays time in minutes and seconds.
The center window Dive Timer is activated at the start of the dive and it can be reset during
the dive and used as a stopwatch by pressing the SELECT button.
NOTE
NOTE
NOTE
32
Mix number, O %, and PO
2
If the set PO limit is exceeded , it will be shown with the PO
2
blinking. The dive computer does not allow you to change to a gas
whose set PO is exceeded. In such a case, the mix is shown but
2
cannot be selected.
If no button is pressed in 15 seconds, the dive computer will go back
to the dive display without changing the gas mix. Upon ascent, the
computer prompts you to change gas when the PO
set for the next mix allows a gas change. The prompt is an audible 3
beeps and the current O
BY PRESSING THE SELECT BUTTON DURING A DIVE, A BOOKMARK
IS WRITTEN IN THE PROFILE MEMORY, THE DIVE TIMER IS RESET,
AND THE PREVIOUSLY-TIMED INTERVAL IS DISPLAYED BELOW.
The GAUGE mode does not provide decompression information.
There is no ascent rate monitoring in the GAUGE mode.
If you dive with the GAUGE mode, it is not possible to change between
the modes before the no fly time has counted down.
for the mixes are shown when scrolling.
2
mix starts to blink.
2
value
2
level you have
2