Table of Contents
Advertisement
How to Put Your Ceiling Fan Together
8. Slide blade through center slot in fan housing.
Position one blade support plate onto blade.
Mount blade to fan housing using one blade
support plate and secure using three #10 - 24 x
15mm washer head blade screws (Figure 6).
NOTE: Take care not to scratch fan housing when
installing blades.
9. Remove one #8 - 32 x 10mm pan head screw from
the lower housing adapter (reserve for later use).
Loosen the other two screws to assemble the
lower housing to the lower housing adapter
(Figure 7).
10. Position the lower housing onto the fan motor
assembly, aligning each of the the three holes.
Rotate the lower housing to engage the two
loosened screws in the two key hole slots.
Replace the #8 - 32 x 10mm pan head screw
(removed previously) and tighten all three screws
to secure the lower housing to the lower housing
adapter. (Figure 8).
NOTE: Make sure wires are not pinched between
fan motor assembly and lower housing.
11. Engage the connector of the light kit assembly
with the motor connector (Figure 9). The two
connectors are keyed and color-coded and must
be mated correctly (color-to-color) before they can
be engaged. Make sure the connector latch
closes properly.
NOTE: Make sure all wires and connector are
tucked under the light kit assembly and not
pinched between light kit assembly and lower
housing.
12. Remove one #8 - 32 x 10mm pan head screw
from the lower housing (reserve for later use).
Loosen the other two screws to assemble the
light kit assembly to the lower housing (Figure 9).
13. Position the light kit assembly onto the lower
housing, aligning each of the the three holes.
Rotate the light kit assembly to engage the two
loosened screws in the two key hole slots.
Replace the #8 - 32 x 10mm pan head screw
(removed previously) and tighten all three screws
to secure the light kit assembly to the lower
housing. (Figure 10).
Figure 6
#8 - 32 x 10mm PAN HEAD SCREW (3)
Figure 7
LOWER
HOUSING
Figure 8
Figure 9
KEY HOLE
SLOT (2)
Figure 10
6
(continued)
#10 - 24 x 15mm WASHER HEAD
BLADE SCREWS (3 per blade)
BLADE SUPPORT PLATE
CENTER SLOT
FAN HOUSING
SLIDE FAN BLADE
INTO CENTER SLOT
FAN
BLADE
LOWER HOUSING ADAPTER
#8 - 32 x 10mm PAN
HEAD SCREW (3)
LIGHT KIT ASSEMBLY
LIGHT KIT ASSEMBLY WIRE
CONNECTOR
MOTOR HOUSING WIRE
CONNECTOR
#8 - 32 x 10mm PAN
HEAD SCREW (3)
LIGHT KIT ASSEMBLY
#8 - 32 x 10mm
PAN HEAD SCREW
(3)
U.L. Model No.: CF850
Advertisement
Table of Contents
