Table of Contents
Advertisement
How to Put Your Ceiling Fan Together
3. While pulling up on the downrod, securely tighten
the two setscrews in the motor coupling (Figure 3).
NOTE: The setscrews must be properly installed
as described above, or fan wobble could result.
4. Make sure the grommet is properly installed in the
coupling cover then slide the coupler cover on the
downrod until it rests on the motor housing. Place
the ceiling cover over the downrod. Be sure both
the ceiling cover and the coupler cover are oriented
correctly (Figure 3).
5. Reinstall the hanger ball (Figure 4) on the downrod as
follows. Route the motor leads through the downrod.
Position the pin through the two holes in the downrod
and align the ball so the pin is captured in the groove
in the top of the hanger ball. Pull the hanger ball up
tight against the pin and securely tighten the setscrew
in the hanger ball. A loose setscrew could create fan
wobble.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are
properly installed could result in the fan falling.
6. The fan comes with blue, black and white leads
that are 80" long. Before installing fan, measure up
approximately 6 to 9-inches above top of hanger
ball/downrod assembly. Cut off excess leads and
strip back insulation 1/2-inch from end of leads.
7. Turn fan motor assembly upside down in
preparation for mounting fan blades. Position the
top and bottom halves of the styrofoam packaging
on end, with solid styrofoam facing outward. Set
side-by-side on the floor with a six to eight-inch gap
between the halves (Figure 5). Carefully place the
partially assembled ceiling fan on the styrofoam
halves, with the hanger ball/downrod assembly
positioned in the gap and the fan motor assembly
resting on top of the styrofoam ends.
PIN
HANGER
BALL
CEILING
COVER
DOWNROD
Figure 3
HANGER
BALL
PIN
DOWNROD
Figure 4
6" - 8"
GAP
Figure 5
5
(continued)
SETSCREW
COUPLING COVER
CEILING
COVER
SETSCREW
PARTIALLY
ASSEMBLED
FAN
SOLID
STYROFOAM
FACING OUT
U.L. Model No.: CF850
Advertisement
Table of Contents
