Direct Dialling Code Selection; Disa; Recording Outgoing Message (Ogm); Recording Through An Internal Phone - Linkcom Link Gate GSM ISDN User Manual

4.4.

Direct dialling code selection

The incoming calls can be handled in tw o ways:
All calls can be automatically connected to a selected extension in the connected exchange
4.4.1.
Connection takes place in accordance w ith the selected MSNs (DDI) or direct dialling numbers of
the operator separately for each channel. In this w ay, it is even possible to distinguish the calls
incoming to individual telephone numbers of the GSM channels of the gate – the calls incoming to
the telephone number of the first channel w ill be connected to the direct dialling code 11, incoming
calls to the number of the other channel e.g. to the direct dialling code 12.
If a number of digits in the direct dialling code are being set, the number w ill be higher than zero
(max. 4 –
Caution: the number should correspond w ith the number of digits of the direct dialling code of the
exchange and selected MSNs or DDIs of individual GSM modules!),
the callers may themselves dial directly using tone selection by preset number of digits to the
required extension. The automatic operator w aits for a pre-selected number of seconds for direct
dialling code selection. If it is not selected, the pre-selected number of the operator (according to a
channel the call is incoming from) is dialled again.
4.5.

Recording Outgoing message (OGM)

You can choose to dial directly an internal phone (DISA). You can leave the messsage to invite the
caller to compose an internal phone number or to indicate that he w ill be route to operator.This is
useful to guide the caller.
4.5.1.
The gate can be provided additionally w ith a board with a digital recorder of "messages" for
individual GSM channels. When collecting an incoming call through direct dialling, these messages
are alw ays replayed. If the "rec" field has been checked, 2 extensions accessible from a number in
GSM1 module are added in the system: message for GSM1 w ith the number 1 and a message for
GSM2 w ith the number 2. After establishing connection w ith the number for the GSM1 module
dialling the corresponding direct dialling code (*1 or *2), a short tone w ill sound – alerting to start of
recording. After message recording (max. 10 sec.), the record is terminated by hanging up.
Caution! You m ust select a 2-digit direct dialling code!
Ce document est la propriété de Linkcom.
Toute reproduction même partielle est strictement interdite

DISA

Recording through an internal phone

classe
Option
classement
LGISDNeng 6.5
DR
Number of digits of
direct dialling code
numéro date
09/11/04
002.02
page
13/22