KMC Controls FlexStat BACnet Operation Manual page 22

• Single Setpoint will keep the setpoint at what-
ever the user has last selected (except when a
motion sensor optionally puts the FlexStat in
standby mode—see
8). The FlexStat will stay On (in occupied mode),
and the schedule will be ignored.
• To use the Schedule option, the schedule must
be configured before entering Hospitality mode.
(See Schedules on page
ured by the user, the default schedule is always
On (occupied).
(Hospitality Mode Sample Screens)
WED 10/01
HUM: 46% RH
Pushing Enter Button Toggles
°F/°C Temperature Scale
Pushing Left Button
Goes to Field A Screen
SYSTEM MODE
AUTO
HEAT
COOL
OFF
(No Field C Screen Exists)
NOTE: In Hospitality mode, users have continuing
control over single, occupied, and
unoccupied setpoints. Under the Single
Setpoint option, the setpoint will remain
at whatever value was last selected by a
user until a user adjusts the setpoint again.
Under the Schedule option, the setpoint
values persist even after switching between
FlexStat
Motion Sensor Setup on page
24.) If no schedule is config-
3:20 PM
(Field A Selection)
COOL
(Field B Selection)
HIGH
(Field C Message)
WELCOME
(Rotation Value)
(Pushing
Button
Goes to
Field B
Screen)
scheduled occupied and unoccupied
periods. For example, if a user changes
the occupied cooling setpoint to 76°, the
occupied cooling setpoint will remain at 76°
on subsequent days until a user adjusts it
again. The same is true for the unoccupied
setpoint. To automatically reset setpoints
to default values at particular times, a
building automation system can overwrite
the setpoint value objects or custom
programming can be put into the FlexStat.
See the FlexStat Application Guide.
Custom Hospitality mode programming is required
for:
• Use of Field C for displaying messages.
• Creating additional/alternate menu options.
• Any use of AHU or RTU applications in firm-
ware R1.3.0.11. (Firmware earlier than R1.3.0.11
did not support Hospitality mode at all, and
R1.3.0.11 natively supported only FCU or HPU
applications in Hospitality mode. The latest firm-
ware supports all the applications.)
• Automatic periodic resetting of setpoints to a
default after a user has changed them.
See the FlexStat Application Guide for more infor-
mation about custom programming for Hospitality
Right
mode.
NOTE: If this new feature does not work (is
"Inactive") after upgrading the firmware
(especially from R1.3.0.4 or earlier), you
may need to restore the factory default
(especially if there is custom programming
or configuration in the FlexStat) and
reconfigure the FlexStat. See
Factory on page
NOTE: Auto in System Mode does not currently
have an icon implemented with it.
Manually selecting Heat or Cool will
display an icon on the Home screen.
22
Restore
27.
Operation Guide, Rev. Q