Checking Of The Fuel Pump's Air Filter; Checking The Level Of Battery Acid; Ignition System - Husqvarna Rider 15V2 Operator's Manual

Checking of the fuel pump's air filter

Check regularly that the fuel pump's air filter is free
from dirt. The filter can, when necessary, be
cleaned with a brush.
• Remove the screws and fold out the pump
from the bracket. No hoses are to be removed.
• Reinstall the pump to the bracket.
Check the level of the battery acid
Check that the level of the battery acid lies between
the markings. Top up the cells with only distilled
water.
WARNING!
Procedures on contact with acid
External: Rinse well with plenty of water.
Internal: Drink large quantities of water or
milk. Contact a doctor as soon as
possible.
Eyes: Rinse well with plenty of water.
Contact a doctor as soon as
possible.
Batteries emit explosive gas. Sparks, flames
and cigarettes must absolutely not be
brought into the vicinity of the battery.

Ignition system

The engine is equipped with an electronic ignition
system. Only the spark plugs require maintenance.
For recommended spark plug, see chapter
"Technical data".
IMPORTANT INFORMATION
Fitting the wrong spark plug type can
damage the engine.
1. Remove the ignition cable shoe and clean
around the spark plug.
2. Remove the spark plug with a 3/4" (19 mm)
spark plug socket wrench.
3. Check the spark plug. Replace the spark plug if
the electrodes are burned or if the insulation is
cracked or damaged. Clean the spark plug with
a steel brush if it is to be reused.
4. Measure the electrode gap with a gapping tool.
The gap should be 0.75 mm/0.030". Adjust as
necessary by bending the side electrode.
MAINTENANCE
IMPORTANT INFORMATION
Inadequately tightened spark plugs can
cause overheating and damage the
engine. Tightening the spark plug too
much can damage the threads in the
cylinder head.
5. Reinsert the spark plug, turning by hand to
avoid damaging the threads.
6. After the spark plug is seated, tighten it using a
spark plug wrench so that the washer is
compressed. A used spark plug should be
turned 1/8 of a turn from the seated position. A
new spark plug should be turned
1/4 a turn from the seated position.
7. Replace the ignition cable shoe.
8009-147
6008-013
27
English –