Maintenance; Maintenance Schedule - Husqvarna Rider 15V2 Operator's Manual

The following mainteneance items should be conducted on the machine. For the items not described in
these instructions, ask an authorised service workshop.

Maintenance

Check the engine's oil level
Check the engine's cooling air inlet
Check the fuel pump's air filter
Check the steering wires
Check the battery
Check the safety system
Check screws and nuts
Tighten screws and nuts
Check for fuel and oil leakage
Clean around the silencer
Change the engine oil
Change the oil filter 2)
Check the cutting unit
Check the tyre pressures 60 kPa/8.5 PSI
Lubricating the belt adjuster
Lubricate joints and shafts
Check the V-belts
Clean the hydrostat's cooling fins
Check the transmission's oil level
Adjust the brakes
Check and adjust the throttle wire
Check and adjust the choke wire
Clean the engine's and hydrostat's cooling flanges
Clean the foam element in the air filter
Clean/Replace the paper element in the air filter
Check or clean the air intake screen
Clean dust and dirt from cylinder and
cylinder head fins
Replace the fuel filter
Clean and replace spark plugs
Clean combustion chambers
Check and adjust valve clearence
Clean and lap valve seating surface
1)
First change after 8 hours. Replace after every 50 hours with heavy loads or high temperatures.
3)
hours. For daily use of the machine, lubrication should be conducted twice a week.
replacement should be more frequent.
200 hours.
= Described in these instructions.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cable is removed from the plug.
22
– English
MAINTENANCE

Maintenance schedule

1)
3)
3)
4)
5)
5)
5)
5) Conducted by an authorised service workshop.
= Not described in these instructions.
Daily
maintenance
before start
Page
41
29
27
24
27
28
–
–
–
–
42
42
32
29
43
43
–
–
43
24
25
25
4,5)
–
4,6)
25
27
4)
During dusty conditions cleaning and
6) Replace the paper element yearly or every
• The parking brake is applied.
• The cutting unit is disengaged.
Maintenance interval
in hours
25 50 100
1) 1)
2)
Change the oil filter every 200
200