Checking The Engine's Cooling Air Intake; Fitting The Cutting Head - Husqvarna Rider 15V2s AWD Operator's Manual

Checking the engine's cooling air
intake
Clean the air intake grille in the engine cover behind the
driver's seat.
Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dirt.
Check the air duct, located on the inside of the engine cover,
ensure it is clean and does not rub against the cooling air
intake.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
WARNING! The cooling air intake rotates
!
when the engine is running. Mind your
fingers.

Fitting the cutting head

WARNING! Wear protective glasses when
!
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
3
1
1 Place the Rider on a flat surface and apply the parking
brake.
26 –
English
Maintenance
2 Check that the lever for setting the cutting height is in the
3 Grasp the handle at the front or hold the frame of the
4 Check that the pin is fitted correctly.
5 Insert the bolt and secure it with a locking pin.
6 Press down the frame and remove the pin.
2
lowest position and that the lifting lever for the cutting unit
is in mowing position.
Make sure the support wheels (1) are fitted to the cutting
unit.
cutting unit (2) and slide the unit underneath the rider
mower.
WARNING! Observe caution to avoid
!
trapping your hand.