Brother DCP-J125 User Manual page 63

Error Message
Cannot Detect
Cannot Print
Replace Ink
Cover is Open
Data Remaining
Document Jam
(DCP-J715W only)
High Temperature
Hub is Unusable.
Image Too Long.
Image Too Small.
Ink Absorber Full
40
Cause
You installed a new ink cartridge
too quickly and the machine did
not detect it.
If you are using non Brother
Original ink the machine may not
detect the ink cartridge.
An ink cartridge is not installed
correctly.
One or more of the ink cartridges
have reached the end of their life.
The machine will stop all print
operations.
The scanner cover is not
completely closed.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The document was not inserted
or fed correctly, or the document
scanned from the ADF was too
long.
The print head is too warm.
A Hub or USB Flash memory
drive with Hub has been
connected to the USB direct
interface.
The proportions of your photo
are irregular so effects could not
be added.
The size of your photo is too
small to trim.
Internal servicing required.
This problem may be caused by
the use of cartridges other than
genuine Brother Original
cartridges or the refilling of empty
cartridges with ink from other
sources. If damage is caused to
the print head or other parts of this
machine as a result of using other
brands of ink or ink cartridges, any
repairs required as a result may
not be covered by the warranty.
Action
Take out the new ink cartridge and
re-install it slowly.
Replace the cartridge with a Brother
Original ink cartridge. If the error message
remains, contact your Brother dealer.
Take out the new ink cartridge and
re-install it slowly until it clicks. (See
Replacing the ink cartridges on page 33.)
Replace the ink cartridges. (See Replacing
the ink cartridges on page 33.)
Lift the scanner cover and then close it
again.
Firmly close the ink cartridge cover until it
clicks.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
(See Using the ADF (DCP-J715W only)
on page 21.)
(See Document jam (DCP-J715W only)
on page 43.)
Allow the machine to cool down.
A Hub or USB Flash memory drive with
Hub are not supported. Unplug the device
from the USB direct interface.
Choose a regularly proportioned image.
Choose a larger image.
Call Brother Customer Service / your
Brother dealer.