To Unlock The Doors - RAM Truck 2011 Owner's Manual

To Unlock The Doors

Press and release the UNLOCK button on the RKE
transmitter once to unlock the driver's door (If EVIC is
setup for driver door first, otherwise this will unlock all
doors), or twice within five seconds to unlock all doors.
The turn signal lights will flash to acknowledge the
unlock signal. The illuminated entry system will also
turn on.
Remote Key Unlock, Driver Door/All Doors First
This feature lets you program the system to unlock either
the driver's door or all doors on the first press of the
UNLOCK button on the RKE transmitter. To change the
current setting, proceed as follows:
• For vehicles equipped with the EVIC, refer to "Electronic
Vehicle Information Center (EVIC)/Customer-Program-
mable Features (System Setup)" in "Understanding Your
Instrument Panel" for further information.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 21
• For vehicles not equipped with the EVIC, perform the
following procedure:
1. Press and hold the LOCK button on a programmed
RKE transmitter for at least four seconds, but no longer
than ten seconds. Then, press and hold the UNLOCK
button while still holding the LOCK button.
2. Release both buttons at the same time.
3. Test the feature while outside of the vehicle by press-
ing the LOCK/UNLOCK buttons on the RKE transmitter
with the ignition switch in the OFF position and the key
removed.
4. Repeat these steps if you want to return this feature to
its previous setting.
2