Controlling The Vsti By Using The Control Knobs - Yamaha KX25 Owner's Manual

Using the KX with Cubase

Controlling the VSTi by using the CONTROL knobs

Operating the CONTROL knobs on the KX panel edits or controls various parameters of the VSTi used on the
computer. The KX provides the 30 Control Templates which can be used for the VSTi software synthesizers.
By selecting the desired one from 30 Control Templates, you can assign the functions appropriate for the
current VSTi to the CONTROL knobs.
When using Cubase, selecting an Instrument track or changing the VSTi assigned to the current track will
change the Control Template on the KX automatically. This means that you need not select the Control
Template manually when using Cubase.
When the Top display is shown, the names of the parameters to be adjusted via the CONTROL knobs are
shown normally. When controlling the knob, the values of the parameters are shown for a while then the
original display appears again.
Using the Automation function of Cubase lets you record your knob operations to an Instrument track. For
details about the Automation function, refer to the manual of Cubase.
NOTE
· For details about the available Control Template, refer to the Control Template List on page 43.
· The time of the value indication can be changed. For details, refer to "Utility Settings" on page 34.
· When using the DAW other than Cubase, you need to change the Control Template manually via the KX
panel operation.
22
Use these knobs to adjust the values of the VSTi parameters.
Eight parameters can be adjusted because you can switch the parameter assignment
by using the Knob Functions Select button.
Use this button to switch the parameters to be adjusted via the
CONTROL knobs (between parameters 1–4 and 5–8).
This lamp lets you confirm which parameter set (1–4 or 5–8) is
assigned to the CONTROL knobs.
Owner's Manual