Cutting Blades - Husqvarna PZ5426 FX / 966060901 Operator's Manual

Cutting Blades

In order to attain the best mowing effect, it is
important that the blades are well sharpened and not
damaged.
Bent or cracked blades or blades with large nicks
should be replaced.
Blades damaged from hitting obstacles that result
in a breakdown should be replaced. The service
workshop should decide whether the blade can be
repaired/ground or must be replaced. Balance the
blades after sharpening.
Check the blade mounts.
Blade Replacement
WARNING!
Blades are sharp. Protect your
hands with gloves and/or wrap
blades with a heavy cloth when
handling.
1. Remove blade bolt by turning counterclockwise.
2. Install new or re-sharpened blade with stamped
"GRASS SIDE" facing towards ground/grass
(down) or "THIS SIDE UP" facing deck and
cutter housing.
3. Install and tighten blade bolt securely.
4. Torque blade bolt to 90 ft-lbs (122 Nm).
IMPORTANT INFORMATION
Special blade bolt is heat treated.
Replace with a Husqvarna bolt if required.
Do not use lower grade hardware than
specified.
48
maINTeNaNCe
IMPORTANT INFORMATION
The sharpening of blades should be carried
out by an authorized service workshop.
1. Blade
2. Blade bolt (special)
3. Cutter housing
Blade attachment
WARNING!
Blades are sharp. Protect your
hands with gloves and/or wrap
blades with a heavy cloth when
handling.
1
2
3
8065-028