Prosharp SkatePal-Pro² Original Instructions Manual page 6

Adjusting the grinding wheel sideways
Adjust the grinding wheel in small steps, 1/8 round at the time. An easy way of changing
position of the grinding wheel is to first drive the wheel to the left, so you get more room to
adjust the screw. To do this, push start button for five seconds and keep the button down.
Wheel will start go to the left without grinding. Once you let go off of the start button, the
wheel will stop. (If you want the wheel even further left, push the button again for five
seconds and repeat previous steps).
Push once more and the wheel will come back to the home position
Adjusting of the centering of the grinding wheel can be done by screwing the thumb screw.
Clockwise moves the wheel towards you and anti-clockwise moves the wheel from you.
The thumb-screw can be found beside the grinding wheel, see picture below.
Technical Data
 Power supply unit
A
 Weight
 Length
 Noise level
GRINDING
WHEEL DOOR
START/STOP
CYCLE
POWER
CORD INPUT
150W
32.6 lbs (14.8 kg)
27.5" (700 mm)
80dB
QUICK-RELEASE
HANDLE/CLAMP
VACUUM
CLEANER INPUT
ON/OFF
AC INPUT 100-240 VAC 50/60hz 3.6
8.6" (220 mm)
Width
12.6" (320 mm)
Height