Prosharp SkatePal-Pro² Original Instructions Manual page 5

After grinding
 Unplug the power cord. Clean the machine from dust with a dust cleaner or you can also
use a magnetic stick.
 Unplug the power cord. Clean the machine from dust with a dust cleaner or you can also
use a magnetic stick.
Note
 Every B64 wheel lasts around 1000~ cycles.
Change the grinding wheel according to the instructions. It is worn out when it is no longer
taking away material from the steel and/or gives an unsatisfying result.
 After 1-3 years or around 10,000~ cycles.
Service should be made by an authorized service technician.
Sharpening of skates
1. Clamp the skate into the middle, sideways, of the skate holder, always with the heel of
the skate placed towards the grinding wheel.
2. Choose the sharpening cycles from 1 to 5 by quickly pushing the start button.
1 push is worth of 1 cycle and 5 pushes are worth of 5 cycles.
Grinding is finished when the wheel is back in the start position and the motor has
stopped. Push of the start button during sharpening = turn direction, e.g. for getting rid of
nicks on the blade.
3. Check the sharpening result on the skate blade. (if not perfect, repeat the sharpening)
Emergency stop
Push once the start button when the motor is doing the first half-cycle (going to left).
Grinding will stop and the wheel comes back to the home position. One push after the first
half-cycle (going to right) resets counter and takes the wheel back to start position after the
cycle is finished. Two pushes after the first half-cycle will stop the grinding and takes the
wheel back to home position.
Hollow settings and changing of the grinding wheel
Changing of the SkatePal EP- grinding wheel,
Should only be done when the power cord is disconnected.
1. Choose a grinding wheel with a hollow from 3XS to 2XL. It correlates to a hollow
radius from 7mm hollow = XXS (7mm) to 28mm =2XL (28mm) to entirely flat = XX.
Other radius of hollows can be ordered from ProSharp with an 8 weeks delivery time.
2. Open the grinding wheel door; release the grinding wheel thumbscrew by turning to
the left. Remove the wheel and replace it with another wheel. Return the thumbscrew
and tighten it gently by turning to the right.