Table of Contents
Advertisement
Ofrecido por www.electromanuales.com
Instructions for Use
4.3.5 Power management
To optimise the energy consumption, the groups made up of two
hotplates (see figure above) are prevented from supplying more than
a determined maximum operating power. If the value set for the two
hotplates exceeds the permitted power, the electronic circuit board
will automatically maintain the maximum level permitted modifying
the power supplied by the hotplates. The power level selected by the
electronic circuit board will still be visible on the display.
4.3.6 Control circuit board thermal protection
If the cooking zones cause overheating of the internal electronic
circuit board, the heat will be switched off automatically. This switches
off power to the hotplates and F7 will light up on the power LEDs.
4.4 Limitations to the operating duration
The electronics of this appliance limit the cooking duration
according to the power selected. After the maximum time period
has gone by, the cooking zone switches off, the appliance emits an
audible signal and AS(automatic stop) appears on the display.
Power level set
Levels 1 to 9
4.5 Error messages from the electronic circuit board
The electronic circuit board has been designed to protect the hob
components from malfunctions that can damage them. For this
purpose, some error messages have been provided, visible through
the power display. If error codes from F1 to F9 , should appear on
the display, call the authorised service centre and tell them the error
code you have read.
If the display appears in this way
heard, it means that a metal object has been left inadvertently on
the hob and that it could become hot if the hob is switched on.
Maximum cooking duration in hours
8 hours' cooking at most
and an acoustic BEEP is
16
Advertisement
Table of Contents
