Requirements For Network Connection - AddPac AP-VP500 Installation And Operation Manual

AP-VP500 Video Phone Installation & Operation Guide, Release 1.00

Requirements for Network Connection

This procedure is to follow EIA standards and other EMI regulations when you install the
Gateway
The following section describes the Ethernet Cable, and the Console Cable which can be
connected to the AP-VP500.
Required Tools and Equipment
Some cables and equipment are not included and your need to purchase them separately. Please
prepare the following tools and equipment
LAN Cable & Console Port Cable
RJ-45 to RJ-45
RS232C console cable with RJ-45 connector (included in the box
Ethernet Port
The AP-VP500 has two RJ45 type of 10/100 BaseTX Ethernet ports on the rear side and LED for
indicating the status of the port on the front. These ports are physically connected and using the
direct cable you can connect to LAN0/ LAN1. Please use the standard cable and connector to
access to LAN. You may refer to the cable details of Appendix in this guide
.
Console Port
AP-VP500 has one RJ-45 type3 of RS-232C Female DCE Connector Interface. Through this port,
you can perform the initial setup, monitoring and debugging the system. The cable and connector
must be used. You may refer to the pin connection for RS-232 console cable of appendix in this
guide.
AddPac Technology Proprietary & Documentation
30