Table of Contents
Advertisement
AP-VP500 Video Phone Installation & Operation Guide, Release 1.00
* Configuring IP and Default Route
VP500# configure terminal
Enter configuration commands, one per line. End with CNTL/Z
VP500(config)# interface fastethernet 0/0
VP500(config-if)# ip address 172.20.103.1 255.255.0.0
VOIP_INTERFACE_DOWN
VOIP_INTERFACE_UP : (172.20.103.1)
VP500(config-if)# exit
VP500(config)# ip route 0.0.0.0 0.0.0.0 172.20.1.1
VP500(config)# end
VP500#
VP500# write
Proceed with write? [confirm]
Building configuration...
[OK] Configuration saved to flash:/apos.cfg
* Performing Ping Test to the Default Router
VideoPhone# ping 172.17.201.232
PING 172.17.201.232 (172.17.201.232: 56 data bytes
64 bytes from 172.17.201.232: icmp_seq=0 ttl=64 time=5 ms
64 bytes from 172.17.201.232: icmp_seq=1 ttl=64 time=5 ms
64 bytes from 172.17.201.232: icmp_seq=2 ttl=64 time=5 ms
64 bytes from 172.17.201.232: icmp_seq=3 ttl=64 time=5 ms
64 bytes from 172.17.201.232: icmp_seq=4 ttl=64 time=5 ms
64 bytes from 172.17.201.232: icmp_seq=5 ttl=64 time=5 ms
64 bytes from 172.17.201.232: icmp_seq=6 ttl=64 time=5 ms
--- 172.17.201.232 ping statistics ---
7 packets transmitted, 7 packets received, 0% packet loss'
round-trip min/avg/max = 5/5/5 ms
VideoPhone#
If the result of the ping test is good, the command entry for console to make a video call is completed.
OK
AddPac Technology Proprietary & Documentation
Fast Ethernet Interface Port 0
→ IP Address Setting
→ Default Route Setting
→ Go to General Mode
→ Save Settings
238
Advertisement
Table of Contents
