LG WM0742H Series Training Manual page 23

TRAINING MANUAL WM0742HGA
ALLERGIENE™
The Allergiene™ cycle is designed to use hotter wash water (140° F or 60° C) than the
regular HOT wash (112° F or 50° C) but not as hot as the SANITARY cycle (158° F or
70° C). Its purpose is to remove all allergens, such as dust mites and their eggs and
droppings, as well as lint and dead skin cells. This machine is certified allergy and asthma
friendly by the Allergy and Asthma Foundation of America as removing 95% of harmful
allergens. When the Allergiene™ cycle is operating, the display shows 1:50 at the
beginning, the water level defaults to approximately 242 and spin defaults to HIGH. The
steam generator operates as does the wash water heater in the bottom of the tub.
SANITARY
The sanitary cycle is used to reduce bacteria and germs, as in baby clothes and sick room
linens. The wash water temperature defaults to 158° F (70° C) and cannot be adjusted.
BULKY / LARGE
The BULKY / LARGE cycle is designed to launder large items like tablecloths and bed
covers. It is NOT intended as an opportunity to overload the machine. Just because an
item can be forced into the tub is not evidence it can be successfully laundered there. In
every case, the laundry must be able to tumble to be cleaned effectively. If you push a
king-sized comforter into the tub, but it is so compressed it cannot tumble, it cannot be
washed or rinsed effectively. Further, it will be unable to distribute itself within the drum
for the spin cycle, and will cause the machine to run off balance and shut down because it
cannot redistribute the load. Such large items should be taken to a commercial self-
service laundry where oversized machines are available.
In the BULKY / LARGE cycle, the cycle time is preset. The default selections can be
overridden for wash temperature, spin speed, and soil level. If a selection is not
permissible with the cycle, the machine will beep and refuse to accept the setting.
COTTON / NORMAL
The COTTON / NORMAL cycle is the most often used cycle. It defaults to a 0:53
minute cycle time, but this may vary as the fuzzy logic makes numerous adjustments
throughout the cycle. It is the only cycle that genuinely senses the load before displaying
the approximate wash time. The water level defaults to approximately 239. The default
selections can be overridden for wash temperature, spin speed, and soil level.
WM0742HGA Page 21 TRAINING MANUAL