TRAINING MANUAL
This procedure covers installing and leveling the 7½" and 13" pedestals for 27" washers,
dryers, and combos. If the products are stacked, the washer must be below the dryer,
and only one pedestal is required.
WM0742HGA
INSTALLATION
Remove the pedestal, installation hardware,
and instructions form the shipping carton.
Set the pedestal as close to the installation
position as possible.
Level the pedestal on a flat, solid floor
before proceeding. Lock down the rear
adjusters but leave the front ones free
for now.
Note which holes are for the washer and
which are for the dryer. If you are stacking
the appliances, the washer must be on the
bottom.
Remove the protective paper from the
adhesive surface of the bracket. Be
particularly careful, because when the
adhesive makes contact, no adjustment is
possible.
Page 15
(PEDESTAL KIT)
WM0742HGA
TRAINING MANUAL