Input Screen For Route Guidance; Main Menu Navigation - Skoda Columbus Operating Instructions Manual

Using a new navigation DVD/Updating the navigation data in the system
›
Insert the navigation DVD into the CD/DVD slot with the printed side facing up
until it is automatically drawn in. The device compares the data on the naviga-
tion DVD with the data in the device memory. If the data in the device memory
is identical to the data on the navigation DVD, no message will appear.
›
If the data on the navigation DVD is not identical to the data in the device
memory, a corresponding message will appear. Press the function key
to used the data on the navigation DVD.
›
Press the function key to overwrite the data in the device memory with
Save
the data on the navigation DVD. During the copy or update process, the old
navigation data will be irretrievably deleted and cannot be restored.
›
Press the button → to get a notification when the storage process has
Notify

finished.
Use data of a navigation DVD for a short period of time
›
If you leave the stored area map in the device memory for only a short period of
time, insert the navigation DVD for the area you will be driving in.
›
Press the function key
Continue →
the navigation DVD for the navigation.
›
If you are once again in the area of the map material stored in the device memo-
ry, press the key to remove the navigation DVD.

Up to date navigation data and new navigation DVD
Road guidance is subject to constant changes (e.g. new streets, changes of street
names and house numbers). A navigation DVD is a huge data store, which un-
fortunately will not be up to date after a certain time. This could cause problems
during route guidance.
It is for this reason that you must regularly update the navigation data on your
unit with a current navigation DVD.
Version of the navigation data
Keep pressing the button
SETUP →
4-digit code number which is the version of the navigation data. Further informa-
tion is available from a ŠKODA Partner.

Input screen for route guidance

Selecting a destination from the list
›
If function key is pressed after the input screen has been opened, a list will

appear of all destinations that can still be selected from the device memory in
line with the requirements (e.g. for
30
NAV mode (Navigation)
. The unit uses only the data from
Temporarily
until you see a
Version info → Map version DVD
and ).
country city
›
If necessary, move the slider at the right edge of the touch-screen for all entries
in the list to be displayed.
›
Press the desired entry in the list to take it over for the address.
Limit destination and select from the list
›
You can open a list of the selectable destinations any time by pressing the func-
tion key while entering a destination in the entry line. The list only displays
**
Continue
the destinations that match the requirements, that match the character se-
quence in the entry line and that are saved in the device memory.
›
The number of selectable destinations will be displayed in the function key
fewer than one hundred destinations can be selected.
›
If fewer than six destinations are selectable, the input screen will close auto-
matically and a list of possible destinations will be displayed.

Main menu Navigation

Introductory information
Press the button
NAV
■ Options - opens the menu for defining the route options

key "Options"
- split-screen with the coordinates of the position where you are cur-
■ Curr. pos.
rently located
- stores the current position as "Flagdest." in the destination memory.
■

- used for the entry of a new destination.
■ New dest.
■ - enter an address in the input screen to specify the destination ad-
Address

dress » page 31, Function key " Address"
- open the search screen for searching for a point of interest from a
■ POI

specific category or by entering a name or a telephone number
Function key " POI"
Fig. 14
Main menu Navigation with ad-
dress.
.
if
**

» page 31, Function
» page 32,
