Table of Contents
Advertisement
Available languages
Available languages
ASSEMBLY INSTRUCTIONS
CAUTION: You must attach the handle before operating the charger.
REQUIREMENTS
• handle
• four screws
• screwdriver
ATTACHING THE HANDLE
To attach the charger handle:
1. Locate the handle and four screws provided. The charger comes with one of two types of
handles.
2. Remove the top two screws at the rear from both sides of the charger.
3. Straddle the handle over the charger and align the mounting holes. If the charger has the Type
2 handle, make sure the handle is flush with the edge of the charger. Refer to the drawing
below.
4. Attach the handle with the four screws and tighten securely.
Notice offset of holes
to orient handle correctly.
6
Advertisement
Table of Contents
