Draining Your Spa - Master Spas Down east Owner's Manual

REGULAR MAINTENANCE PROCEDURES

dRaININg yOUR Spa

The drain is located behind the front panel on the far right side. You can access the drain by
unscrewing the black thumb screws and removing the corner panel. Grasp the drain cap, and pull
the assembly out all the way. Unscrew the cap, then push the assembly back in half way to start
the flow of water. Attach a garden hose, if desired. Draining times may vary by model using the
external hose bib. A sump pump may also be used to drain the spa quickly.
NOTE: When pushing or pulling the assembly in or out, water will drip from the drain during
the transition. This is normal.
Spa Drain
RepLacINg yOUR LIghT BULB (NON L.e.d.)
If your light bulb goes out, it is very easy to replace.
Use a 12 volt, 6 watt bulb that should be available through your dealer.
First, make sure the power to the spa is off. You can access the spa light fitting by removing the spa
panel.
Once the panel is removed, unfasten the black fitting inside the white light assembly, by turning it coun-
ter clockwise.
Attached to the black fitting is the light bulb. Replace the bulb and reinsert the fitting, by turning it
clockwise.
If the white lens cap needs to be removed, insert a flat head screw driver as shown in the picture
below.
DO NOT DIVE.
This may also be necessary
when installing an LED light.
51